Events

Common problems of fedar sublimation printer

September 14, 2020

Fedar sublimation printer manufacturers have summarized some common problems that may be encountered during the use of sublimation printing machine, so that you can solve them and improve printing efficiency.

 

1.Nozzle missing when printing on fedar sublimation printer
Encoder strip is dirty, you need to wipe the upper and lower encoder strip with a cotton swab dipped in clean water. After washing, use a dry cotton swab to dry water.

 

2.Picture printed by fedar sublimation printer is misplaced
①Servo motor is broken and needs to be replaced
②Copper ring is dirty and needs to be cleaned or replaced.

 

3.Fedar sublimation printer head does not inkjet ink
①Trolley board is hot, and fedar sublimation printer needs to be turned off to rest.
②Electric shock strap needs to be replaced if it is broken.
③Fedar sublimation printer head is blocked and needs to be cleaned
④Ink tube interface is blocked, you need to unplug it several times
⑤Printhead interference, exchange printhead positions, and use a paper towel to pad between printhead and electric contact belt to check the specific position and replace printhead.
⑥If there are four printheads that do not emit ink at the same time, the car board is broken.

 

4.Paper cannot be detected
①If the paper measuring device is dirty, wipe it with a cotton swab moistened with clean water.
②Paper tester is not installed properly and needs to be reinstalled.
③Paper tester is broken and needs to be replaced.
④Car board is broken and needs to be replaced.

 

5.Drawing edge is slanted to one side
①Fedar sublimation printer’s servo motor is broken and needs to be replaced.
②Encoder sensor is dirty, so wipe it with cotton swab moistened with clean water. If encoder sensor is broken and needs to be replaced.

 

6.Small car frame hits the left frame of fedar sublimation printer when starting up
①Encoder sensor is dirty and needs to be cleaned.
②Encoder sensor is broken and needs to be replaced.
③If data cable is not plugged in properly, plug it in several times.

 

7.Frequent paper testing
①Paper feed sensor of fedar sublimation printer is dirty and needs to be cleaned.
②Paper feed sensor is not properly connected to main board or contact is not good.
③Paper feed sensor is broken and needs to be replaced.

Fedar Sublimation Printer